VEGA VEGABAR 40 HART - Manual (Page 24)

24 VEGABAR 40 (HART ® )
Setup
Sensor parameter adjustment –
Adjustment
Click to Instrument data , then to Parameter
adjustment .
In the window "Configuration Measurement
loop Modify“, you can assign a name and a
description to the measurement loop. An
unambiguous name is important when you
adjust several sensors or measurement
loops with VVO. State under "Application“ if
you want to have a process pressure or level
measurement. With
OK you again reach the
window "VEGA Visual Operating“. In the
following explanations, we assume that you
have chosen the application "Process pres-
sure measurement“. With the application
"Level measurement“ the adjustment deviates
slightly from the following demonstration.
Confirm this message with OK . Then the
window "Instrument data parameter adjust-
ment“ appears.
From the window "Instrument data parameter
adjustment“ you reach all submenus of the
sensor. We recommend trying the individual
buttons one after the other. Then you always
reach this window. Click to the button
Adjust-
ment to carry out the adjustment .
After this, several HART ® sensors can be
connected to one common cable. The further
adjustments of VEGABAR in Multidrop opera-
tion (e.g. adjustment, measured value dis-
play) do not differ from the adjustments in
standard operation.
Configuration measurement loop
Click to Configuration , point to Measure-
ment loop , then click to Modify .