VEGA VEGAMET 614 - Manual (Page 29)

VEGAMET 614 29
Settings in the "Extended menu“
7.3 Configuration of outputs
Config
inputs Config
meas.
loop Config
outputs
Config
curr.
output
Curr.1
to
TAG -
No. 1
Volt1
to
TAG -
No. 1
Config
Volt
output Config
relay
output Config
PC/
DCS-
outp. Config
VEGA-
DIS
DIS 1
to
TAG -
No. 1
DIS 2
to
----
DIS 3
to
----
PC/
DCS
meas.
values
DCS
1 to
TAG -
No. 1
DCS
2 to
----
DCS
3 to
----
PC/DCS
relay
status
off
PC/DCS
input
status
off
Confi-
gura-
tion
TAG -
No. 1
%
xx,x
Param.
TAG-
No. 1
Fail
safe
relay
Relay
Stan-
dard
Oper-
ating
relay
Rel. 1
to
TAG -
No. 1
Rel. 2
to
TAG -
No. 1
---- ----
---- ----
----
----
PC/DCS output and DIS output:
The PC/DCS signal as well as the DIS signal
are transmitted via the DISBUS. The PC/DCS
output delivers output signals from
VEGAMET to the interface converter
VEGACOM 557. This interface converter
transfers the signals of VEGAMET via differ-
ent standard protocols to connected sys-
tems (DCS/DCS). In the menu items "DCS 1
to“ up to "DCS 3 to…“ the measurement loop
can be assigned or switched off.
In the menu items "PC/DCS relay status“ and
"PC/DCS input status“, it can be specified
that the relay mode and input status will also
be transmitted via the DISBUS.
Up to three external indicating instruments
(VEGADIS 174) can be connected to
DISBUS. In the menu items "DIS 1 to…“ up to
"DIS 3 to–“ the measurement loop can be
assigned or switched off.
In the factory setting, the current, volt and
relay outputs are assigned to measurement
loop "TAG-No. 1“. All outputs can be individu-
ally switched off (----), i.e. prevented from
accessing a measurement loop.