VEGA VEGASON 66 Emitting electronics - Manual (Page 12)

1
2
3
Fig. 11: Mounting the new emitting electronics
1
Emitting electronics
2 Torx screws T15 (4 pcs.)
3 Flange adapter
2 Plug the new emitting electronics onto the flange adapter.
3 Retighten the Torx screws
4 .5 Mounting steps version B
Danger:
Individual wires of the transducer cable have a voltage of
approx. 70 V during operation (see chapter "Mounting
preparations"). There is danger of electric shocks! Carry out
the mounting steps only in the complete absence of line
voltage.
Proceed as follows:
1 Loosen the terminal screws (2) on the housing with the
hexagon spanner size 4
2 Remove the previous emitting electronics
Dismount the pre-
vious emitting elec-
tronics
12 Emitting electronics - for VEGASON 64, 65, 66
Mounting
30205
-EN
-070510