VEGA VEGASON 65 4 … 20 mA_HART four-wire - Manual (Page 16)

11 S ecure screw (3) with lacquer or similar to ensure permanent
tightness of the swivelling holder
12 R otate the connection head in such a way that the cable entry
points downwards (moisture can drain off). Fasten the cylinder
with screws (5); torque max. 5 Nm
13 I nsert the plug at the end of the transducer cable into the socket on
the remote electronics
1
2 3
Fig. 7: Plug connector between transducer and socket of electronics housing
1
Socket electronics housing
2 Plug connector
3 Connection piece, transducer tube
V ersion D is supplied in three parts:
l T ransducer
l T ransducer cable
l
electronics for wall mounting
A ssemble the version as follows:
1 L oosen the hexagon nut (3) on the transducer cable
2 I nsert the transducer tube from below into the mounting opening
G 1A
3 F asten (SW 46) the hexagon nut (3)
4 R emove the plug from below out of the connection head and plug
it into the socket of the transducer tube
Mounting - Version D
16 VEGASON 65 • 4 … 20 mA/HART four-wire
4 M ounting
28782
-EN
-081127