1 short description, 2 insert indicating and adjustment module – VEGA VEGASON 64 Foundation Fieldbus User Manual
Page 29
6 Set up with the indicating and adjustment
module PLICSCOM
6.1 Short description
The indicating and adjustment module PLICSCOM is used for
measured value display, adjustment and diagnosis. It can be mounted
in the following housing versions and instruments:
l
All sensors of the plics
®
instrument family, in the single as well as
in the double chamber housing (optionally in the electronics or
connection compartment)
l
External indicating and adjustment unit VEGADIS 61
Note:
You can find detailed information on the adjustment in the operating
instructions manual of the indicating and adjustment module
PLICSCOM.
6.2 Insert indicating and adjustment module
The indicating and adjustment module can be inserted into the sensor
and removed again at any time. It is not necessary to interrupt the
power supply.
Proceed as follows:
1
Unscrew the housing cover
2
Place the indicating and adjustment module in the desired position
on the electronics (you can choose any one of four different
positions - each displaced by 90°)
3
Press the indicating and adjustment module onto the electronics
and turn it to the right until it snaps in.
4
Screw housing cover with inspection window tightly back on
Removal is carried out in reverse order.
The indicating and adjustment module is powered by the sensor, an
additional connection is not necessary.
Function/Configuration
Mount/Dismount indicat-
ing and adjustment
module
VEGASON
64 • Foundation Fieldbus
29
6 Set up with the indicating and adjustment module PLICSCOM
28793
-
EN
-081127