VEGA VEGASON 64 Profibus PA User Manual
Page 16
11 Secure screw (3) with lacquer or similar to ensure permanent
tightness of the swivelling holder
12 Rotate the connection head in such a way that the cable entry
points downwards (moisture can drain off). Fasten the cylinder
with screws (5); torque max. 5 Nm
13 Insert the plug at the end of the transducer cable into the socket on
the remote electronics
1
2
3
Fig. 7: Plug connector between transducer and socket of electronics housing
1
Socket electronics housing
2
Plug connector
3
Connection piece, transducer tube
Version D is supplied in three parts:
l
Transducer
l
Transducer cable
l
electronics for wall mounting
Assemble the version as follows:
1
Loosen the hexagon nut (3) on the transducer cable
2
Insert the transducer tube from below into the mounting opening
G
1A
3
Fasten (SW 46) the hexagon nut (3)
4
Remove the plug from below out of the connection head and plug
it into the socket of the transducer tube
Mounting - Version D
16
VEGASON
64 • Profibus PA
4 Mounting
28787
-EN
-081127