VEGA PLICSCOM Heating for the indicating and adjustment module - Manual (Page 10)

5 Connecting to voltage supply
5.1 Preparing the connection
Follow the instructions in the operating instructions manual of
the sensor.
The heating must be power with a reliably separated functional
low voltage according to VDE 0106 Teil 101. Further
information is also available in chapter "Technical data".
5.2 Connection procedure
1 Connect the connection cables on the oscillator according
to the operating instructions manual of the corresponding
sensor.
2
3
4
5
1
7
6
Fig. 3: Connection of the sensor in the socket housing
1 Indicating and adjustment module PLICSCOM
2 Connection cables to PLICSCOM (red)
3 Connection cables to the thermostat (red)
4 Connection cables to the cable gland (green)
5 Ground screw
6 Ground cable to the thermostat (black)
7 Connection cables to the thermostat (green)
10 Heating for the indicating and adjustment module PLICSCOM
Connecting to voltage supply
31708
-EN
-061219