VEGA PLICSCOM Heating for the indicating and adjustment module - Manual (Page 7)

4 Mounting
4.1 Mounting preparations
The following tools are required for mounting:
l
Flat wrench SW 24
l
Slotted screwdriver 3 mm
4.2 Dismounting the electronics module
Proceed as follows:
1 Switch off power supply
2 Unscrew housing cover of the electronics compartment
3 Disconnect the connection cables according to the
operating instructions manual of the respective sensor
4 Loosen the two screws (2)
2
1
Fig. 1: Loosen the screws
1 Electronics module
2 Screws (2 pcs.)
5 Pull the electronics out by holding the opening levers.
4.3 Mount the thermostat
Mounting is only necessary when retrofitting the heating.
Tools
Mounting steps
Heating for the indicating and adjustment module PLICSCOM 7
Mounting
31708
-EN
-061219