VEGA PLICSCOM Heating for the indicating and adjustment module - Manual (Page 5)

3 Product description
3.1 Configuration
If the sensor is already ordered with a heating, then the heating
is already mounted.
However, the heating can be mounted also afterwards.
The scope of delivery encompasses:
l
Indicating and adjustment module PLICSCOM with heating
mounted in the sensor
l
Documentation
- a device operating instructions manual
- this supplementary instructions manual
The scope of delivery encompasses:
l
Indicating and adjustment module PLICSCOM with heating
l
Thermostat
l
Cable gland with plug M12x1
l
Documentation
- this supplementary instructions manual
The heating must not be mounted in instruments with Ex
approval.
3.2 Principle of operation
A heating can be integrated so that data can be read out on the
indicating and adjustment module even at extremely low
temperatures.
The heating must be powered with a protective extra-low
voltage according to VDE 0106 part 101. For further
information see also in chapter "Technical data".
The heating for the indicating and adjustment module
PLICSCOM is suitable for all plics ® sensors with single
chamber housing and the external indicating and adjustment
unit VEGADIS 61.
The heating is permanently prepared and must not be
activated in addition. It switches on automatically with
temperatures around -5 °C (+23 °F) and switches off again at
approx. 0 °C (+32 °F).
Components
Scope of delivery - heating
already mounted
Scope of delivery - retrofitting
set
Area of application
Heating for the indicating and adjustment module PLICSCOM 5
Product description
31708
-EN
-061219