4 mount the oscillator – VEGA PLICSCOM Heating for the indicating and adjustment module User Manual
Page 8
Advertising
2
1
3
Fig. 2: Mounting the thermostat
1
Thermostat
2
Cable gland
3
Electronics module
Proceed as follows:
1 Plug the thermostat to the oscillator
2 Remove the blind stopper from the second thread opening
3 Loop connection cable into the housing
4 Screw in the cable gland
5 Tighten the cable gland (3 Nm)
4.4 Mount the oscillator
1 Insert the oscillator carefully.
2 Screw in and tighten the two screws with a screwdriver.
Mounting steps
8
Heating for the indicating and adjustment module PLICSCOM
Mounting
31708
-EN
-061219
Advertising