VEGA VEGABAR 55 4 … 20 mA - Manual (Page 13)

13
4 Mounting
VEGABAR 55 • 4 … 20 mA
36733-EN-130321
4.2 Mounting steps
For mounting VEGABAR 55, a welded socket is required. You can find
these components in the supplementary instructions manual "Welded
socket and seals".
Use the seal belonging to the instrument or a suitable, product-
resistant seal
Screw VEGABAR 55 into the welded socket. Tighten the hexagon
screw on the process fitting with SW 27 (spanner width 27 mm).
Warning:
The housing must not be used to screw the instrument in! Applying
tightening force can damage internal parts of the housing.
Use the seal belonging to the instrument or a suitable, product-
resistant seal
Screw VEGABAR 55 into the welded socket. Tighten the hexagon
screw on the process fitting with SW 27 (spanner width 27 mm).
Warning:
The housing must not be used to screw the instrument in! Applying
tightening force can damage internal parts of the housing.
Seal the flange connections according to DIN/ANSI with a suitable,
resistant seal and mount VEGABAR 55 with suitable screws.
Use the seal suitable for the respective process fitting. You can find
the components in the supplementary instructions manual "Welded
socket and seals".
4.3 Mounting steps, external housing
1. Mark the holes according to the following drilling template
2. Depending on the mounting surface, fasten the wall mounting
plate with 4 screws
Welding the socket
Sealing/Screwing in
Sealing/Screwing in
Sealing/Screwing in
flange versions
Sealing/Screwing in
hygienic fittings
Wall mounting