4 mounting, 1 general instructions, 2 mounting steps – VEGA PLICSMOBILE T61 User Manual

Page 10

Advertising
background image

10

4 Mounting

PLICSMOBILE T61 • External GSM/GPRS radio unit

37700-EN-130228

4 Mounting

4.1 General instructions

In the standard version, the PLICSMOBILE T61 is designed for

wall mounting. Mounting adapters for carrier rail mounting (top hat

rail 35 x 7.5 according to DIN EN 50022/60715) as well as for tube

mounting are optionally available.

Check before mounting if there is sufficient coverage (signal strength)

by the chosen mobile phone provider at the planned location. This

can be simply tested with a mobile phone. Make sure the SIM cards

in the PLICSMOBILE T61 and in the mobile phone are from the same

mobile phone provider. If the radio reception is too weak, you should

search for a better position. In closed rooms this would be, for exam-

ple, close to a window or at least closer to an outer wall. As an option,

an external antenna with complete confectioned cable is available.
Select a mounting location where the instrument is within easy reach

for mounting and connecting as well as for the connection via USB.

To facilitate mounting, the housing can be rotated by 330° without the

use of any tools.
Note:

During operation, a distance of at least 20 cm should be kept between

the antenna and persons working nearby. Operation of the instrument

with smaller distances is not recommended.

Use the recommended cables (see chapter "Connecting to power

supply") and tighten the cable gland.
You can give your instrument additional protection against moisture

penetration by leading the connection cable downward in front of the

cable entry. Rain and condensation water can thus drain off. This ap-

plies mainly to outdoor mounting as well as installation in areas where

high humidity is expected (e.g. through cleaning processes) or on

cooled or heated vessels.

4.2 Mounting steps

The PLICSMOBILE T61 for wall mounting is supplied with a mounting

base for screw mounting.

Fasten the instrument with four appropriate screws (not included

in the delivery) according to the following illustration.

Mounting possibilities

Installation position

Moisture

Wall mounting

Advertising