VEGA PLICSMOBILE T61 - Manual (Page 23)

23
7 Setup
PLICSMOBILE T61 • External GSM/GPRS radio unit
37700-EN-130228
7 Setup
7.1 Adjustment system
A pC with PACTware and respective DTM is required for setup. The
connection is carried out via a standard mini USB cable (in the scope
of delivery). A released SIM card with data transmission option must
be used in PLICSMOBILE T61. A good network coverage of the used
GSM/GPRS network must be available at the place of operation.
Adjustment on the instrument is limited to a test key and an LED. With
these, the operation and the status of the instruments can be checked
(selection of the GSM network, standby …).
4
1 3
2
USB
Status
Test
SIM-Card
Fig. 10: Display and adjustment elements
1 SIM card slot
2 Status indication
3 Key to the test operation
4 Mini-USB interface
Information:
The function description of the key and the status indication is avail-
able in chapter "Mobile phone network and SIM card".
7.2 Connect the PC
The parameter adjustment of PLICSMOBILE T61 is carried out via
PC and USB interface. The required connection is located in the
electronics housing. Keep in mind that proper functioning of the USB
interface can only be guaranteed in the (limited) temperature range of
0 … +60 °C.
If the PC is provided with a Full-Power-USB-Port, the PLICSMOBILE
is powered via the integrated USB power supply. Parameter adjust-
ment is thus possible without connected power supply, but measured
value recording and transmission is not possible. Power supply via
USB is not possible with a Low-Power-USB-Port.
Note:
The connection via USB requires a driver. First install the driver before
connecting PLICSMOBILE T61 to the PC.
The required USB driver is included on the CD "DTM Collection". You
should always use the latest version to ensure support of all instru-
Setup requirements
Display and adjustment
elements
Connection of the PC via
USB