4 mounting steps, external housing – VEGA VEGABAR 51 4 … 20 mA_HART User Manual
Page 15
15
4 Mounting
VEGABAR 51 • 4 … 20 mA/HART
36713-EN-130321
Information:
By slightly increasing or reducing the torque, the current can be set
exactly to 20 mA.
4.4 Mounting steps, external housing
1. Mark the holes according to the following drilling template
2. Depending on the mounting surface, fasten the wall mounting
plate with 4 screws
90 mm (3.54")
R 3,5 mm
(0.14")
3mm
(0.12")
70 mm (2.76")
8 mm
(0.32")
93 mm (3.66"
)
110 mm (4.33"
)
Fig. 6: Drilling template - wall mounting plate
Tip:
Mount the wall mounting plate so that the cable entry of the socket
housing points downward. The socket housing can be displaced by
180° to the wall mounting plate.
Warning:
The four screws of the socket housing must only be hand screwed. A
torque > 5 Nm (3.688 lbf ft) can damage the wall mounting plate.
Wall mounting