3 mounting steps, external housing – VEGA VEGABAR series 80 External housing User Manual
Page 8
8
4 Mounting
External housing • For pressure transmitter VEGABAR series 80
45081-EN-131119
2
1
5 6 7 8
1
2
+
( )
(-)
Fig. 3: Loosen the holding screws of the electronics module
1 Electronics module
2 Screws (2 pcs.)
5. Pull the electronics out by holding the opening levers.
To mount the electronics module into the new housing, proceed as
follows:
1. Insert the electronics module carefully into the new housing.
Information:
The electronics module is connected via a plug. Make sure that the
plug is in the correct position. The marking notch must be in position
"18.00 h".
1
Fig. 4: Plug position in the base of the external housing
1 Notch
2. Screw in and tighten the two screws with the screwdriver.
3. Screw the housing cover back on
The exchange of the electronics module is finished.
As a rule, an exchange of electronics must be documented internally
if Ex applications are involved.
4.3 Mounting steps, external housing
Mounting the electronics
module