VEGA VEGABAR 82 4 … 20 mA_HART - Operating Instructions - Manual (Page 47)

47
6 Set up with the display and adjustment module
VEGABAR 82 • 4 … 20 mA/HART
45028-EN-131010
Menu item Parameter Default value
Lock adjustment Released
Reset - Display
Menu item Default value
Menu language Order-specific
Displayed value 1 Current output in %
Displayed value 2 Measuring cell temperature in °C
Backlight Switched off
Reset - Diagnosis
Menu item Parameter Default value
Sensor status -
Peak value Pressure Actual measured value
Temperature Actual temperature values from meas-
uring cell, electronics
Simulation Process pressure
Reset - Additional settings
Menu item Parameter Default value
PIN 0000
Date/Time Actual date/Actual time
Copy in-
strument
settings
Special pa-
rameters
No reset
Scaling Scaling size Volume in l
Scaling format 0 % corresponds to 0 l
100 % corresponds to 0 l
Current out-
put
Current output - Size Lin. percent - Level
Current output - adjustment 0 … 100 % correspond to
4 … 20 mA
HART mode Address 0
With this function the following device settings are copied.
The following parameters or settings are saved:
•
All parameters of the menu "Setup" and "Display"
•
The menu items "Reset, Date/Time" in the menu "Additional set-
tings"
•
Special parameters
Additional adjustments -
Copy instrument settings