Velleman HAA2801 - Manual (Page 21)

PROGRAMMING FOR FULL FEATURES --- (Supplementary Information)
In the Split-decoded operation mode, the keypad becomes a data entry tool of the system and
its Data I/O port always gives full feature data to the decoder. A keypad of simplified version also
gives full features in Split-decoded mode. You may try to program the required features even from a
simplest keypad to make a full feature system. The programming information supplied here is for the
convenience of the owner who does not own a full feature keypad.
A Split-decoded system with only one keypad is a Master keypad. Just simply program all the features
into it.
In a Split-decoded system with Master and Slave keypads, the major features MUST be programmed
into the Master keypad. The controller will only take these features to operate the system.
The other features can be programmed into each keypad independently. Each individual keypad, no
matter a Master or Slave is required to program with its User PINs, Codes and Cards to operate.
Each Programming Location in this manual is highlighted with
MASTER or INDIVIDUAL for the
owner’s programming convenience.
------- The features MUST be programmed into the Master Keypad.
--- The features required to be programmed into each keypad individually including
the PINs, Codes and Cards. Those features are used in that keypad only and they
can be repeated use in the other keypad(s) in the system.
REMARK:
• The feature of reading EM Cards only available on the keypads with EM Card reader.
• No keypad is supplied with the Access Controller. User has to purchase the keypad seperately.
• Only the keypads with DATA I/O port are compatible with the Access Controller.
SET SYSTEM INTO PROGRAMMING MODE WITH THE MASTER CODE
IMPORTANT NOTE:
1)
2)
3)
4)
MASTER CODE
The Master Code can be a factory set master code or the private
master code that was set by the owner.
Validate the master code with
* *
(or ) .
2-beep confirms a valid master code. The Mains LED (Amber) is constantly ON after the system is
set in the programming mode.
DO NOT TURN OFF POWER while the keypad is in Programming Mode. Otherwise, it may cause
data lost/error to the programmed features in the memory.
The keypad beeps after power up. Wait 1 minute until the end of the power up delay, then key in the
Master Code for setting the system into programming mode.
For the owner’s convenience in programming at the first time, the factory has put a Master Code
0
0 0 0 into the keypad (It is NOT a default code). To compromise security, in all cases, the owner
should program a new Personal Master Code to invalidate the factory set Master Code after the
keypad is owned.
The
Button has two functions in the keypads with Door Bell button. It is a door bell button while
the keypad is in normal operation; and it is equivalent to a
*
Button in programming mode.
0000 **
MASTER CODE VALIDATION
.
. .
21
MASTER
INDIVIDUAL
INDIVIDUAL