Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Speed Control- SpeedBrake '08-09 For use with PowerPDA & Banks iQ User Manual
Page 10
10
97244 v.2.0
Figure 4 OBDII Connector
13.
connect the 8-pin connector from
the Banks SpeedBrake Wire Harness
to the 8-pin connector on the Six-Gun
In-cab cable that does NOT have the
55415X label attached (this is for the
SpeedBrake Module).
14.
Locate the Foot Brake position
switch connector under the dash. See
Figure 5. Disconnect the foot brake
position switch connector.
15.
Locate the Brake Position Switch
intercept connectors on the Banks
SpeedBrake Wire Harness. connect
the female connector on the Brake
Position Switch intercept connectors
to the factory black brake position
switch connector. connect the male
connector on the Brake Position
Switch intercept connectors to
the factory female brake position
connector that was disconnected.
16.
From under the steering column,
loosen the screws that hold the
steering column panel covers in place.
17.
Move the steering column down
to the lowest possible position to aid
in removal of the top steering column
panel. Remove the top steering
column panel. See Figure 6.
CAUTION: Be careful when
removing the top steering column
panel or damage may result.
18.
Locate the tow haul connector
towards the top rear of the steering
column. See Figure 7.
19.
Disconnect the tow haul
connector.