Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Speed Control- SpeedBrake '08-09 For use with PowerPDA & Banks iQ User Manual
Page 8
8
97244 v.2.0
NOTE: If a PDA has been previously
installed in your vehicle, make sure that
all the latest updates and SpeedBrake
Software are installed and it is fully
charged. Please see Section 3 to update
software.
If you have purchased a combination
SpeedBrake/ Tuner Package, install the
Tuner first and ignore the installation
of the OBD-II interface cable. After
completing installation of the Tuner
continue with this manual.
1.
Disconnect the negative (ground)
cable from the battery (or batteries, if
there are two) before beginning work.
Secure the cables so that they do not
come in contact with the battery posts
during the installation.
2.
Remove the bottom steering
column panel by pulling out to release
the retaining clip. See Figure 2.
Removing a Previously Installed
Banks OBD II Interface Cable
3.
Disconnect Banks OBD II interface
cable from the vehicle OBD II
connector.
4.
a
.
For vehicles with PDA’s
installed only, disconnect the
RJ12 connector from the PDA mount
and pull the wire away from the
dash. Refer to Six-Gun Installation
Manual.
b
.
For vehicles with Banks iQ
installed only, disconnect the
RJ12 connector from the Banks iQ
Bridge Module.
c
.
For vehicles with Six-Gun
selector switch installed only,
disconnect the 2-pin six-gun switch
connector from the 2-pin connector
on the six-gun in-cab cable. Remove
the six-gun switch from the vehicle
and plug the holes with the supplied
plugs. Refer to Six-Gun Installation
Manual.
Figure 2 Ford (08-09)