Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Speed Control- SpeedBrake '08-09 For use with PowerPDA & Banks iQ User Manual
Page 14
14
97244 v.2.0
Section 2
MOUNTING AND CONNECTING THE BANkS IQ
Figure 9 Attaching Banks iQ to window mount
If a Banks PowerPDA has been
previously installed, skip to Section 3.
If a Banks iQ has been previously
installed, skip to Section 4.
WARNING: Below 32
o
F (0
o
C) or
above 140
o
F (60
o
C), the Banks iQ
may be susceptible to damage as a
result of extended direct exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the Banks iQ be removed
from its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period of
time. Gale Banks Engineering is not
responsible for damage to Banks iQ
resulting from exposure conditions.
1.
Locate the Window Mount Assembly
in your kit.
2.
Assemble the Banks iQ docking
station to the Universal mount by
inserting and sliding the Universal
mount tab into the docking station
groove. Hand tighten the nut behind
the docking station to hold the docking
station in place.
3.
Attach the window mount to your
Banks iQ. See Figure 9. Align and place
the two (2) lower tabs on the window
mount to the corresponding slots on the
bottom of the iQ first then snap the top
of the iQ into place.
NOTE: Due to the snug fit, use caution
when installing the Banks iQ into the
window mount.
4.
Find a suitable place on the
windshield for ease of access and
viewing of Banks iQ. Use location
shown in Figure 10 as a reference
for mounting Banks iQ in your vehicle.
Loosen the knob and move the swivel
suction plate to achieve desired viewing
angle of the Banks iQ screen. Do a test
fit and note the angle necessary to
achieve the correct viewing angle.