Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Speed Control- SpeedBrake '08-09 For use with PowerPDA & Banks iQ - Manual (Page 6)

6
97244 v.2.0
1.
Before starting work, familiarize
yourself with the installation procedure
by reading all of the instructions.
2.
The exploded views provide only
general guidance. Refer to each step
and section diagram in this manual for
proper instruction.
3.
Throughout this manual, the left side
of the vehicle refers to the driver side,
and the right side to the passenger side.
4.
Disconnect the negative (ground)
cable from the battery (or batteries, if
there are two) before beginning work.
5.
Route and tie wires and hoses a
minimum of 6” away from exhaust
heat, moving parts and sharp
edges. clearance of 8” or more is
recommended where possible.
6.
When raising the vehicle, support it
on properly weight-rated safety stands,
ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides. When raising the front
of the vehicle, put the transmission in
park (automatic) or reverse (manual),
set the parking brake, and block the
rear wheels. When raising the back of
the vehicle, be sure the vehicle is on
level ground and the front wheels are
blocked securely.
CAUTION: Do not use floor jacks to
support the vehicle while working
under it. Do not raise the vehicle
onto concrete blocks, masonry
or any other item not intended
specifically for this use.
7.
During installation, keep the work
area clean. Do not allow anything to
be dropped into intake, exhaust, or
lubrication system components while
performing the installation, as foreign
objects will cause immediate engine
damage upon start-up.
8.
Save this Installation Manual as a
reference for system maintenance and
service.
TOOLS REQUIRED:
• Inch and metric sockets
• Inch and metric combination and
open-end wrenches
• Pliers
• Standard and Phillips head screw
drivers
• Wire cutters
• Scissors
• Foot-pound torque wrenches
Dear Customer,
Your new Banks SpeedBrake
is a uniquely designed braking
system with electronic
controls, designed to achieve
the optimum level of braking
from your vehicle’s engine.
If you have any questions
concerning the installation
of your Banks SpeedBrake
System, please call our
Technical Service Hotline at
(888) 839-2700 between 7:00am
and 5:00pm (PST). If you have
any questions relating to
shipping or billing, please
contact our Customer Service
Department at (888) 839-5600.
Thank you.
General Installation Practices