Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Speed Control- SpeedBrake '08-09 For use with PowerPDA & Banks iQ User Manual
Page 15
97244 v.2.0
15
5.
Make sure the suction cup and the
mounting area on the windshield are
clean and dry. With the suction lever in
the up position, ensure the suction cup
is flat against the windshield, and then
push the suction lever down to secure
in place.
Connecting Banks iQ
6.
Locate the RJ12 cable (similar
to telephone connector) on your
SpeedBrake Wire harness connected
to the vehicle’s OBD II connector. See
Figure 11.
7.
Locate Banks iQ Bridge Module and
connect the RJ12 connector into the
Bridge Module. See Figure 12.
8.
Route the Banks iQ USB interface
cable on the Banks iQ Bridge Module to
reach the Banks iQ and connect it to the
left receptacle on the iQ.
NOTE: You may need to loosen or
remove dash panel or covers to install
the interface cable between dash crevice
or behind dash panels.
WARNING: THE CHARGING CABLE
CONNECTED TO THE BANkS iQ IS
DESIGNED TO SUPPLY A CONSTANT
LOW-VOLTAGE POWER SOURCE
(+5VDC) TO THE BANkS iQ AND IS
“LIVE” AS LONG AS THE SYSTEM’S
OBD II INTERFACE CABLE OR BANkS
WIRING HARNESS IS COMPLETELY
INSTALLED AND THE USB CABLE
CONNECTOR IS PLUGGED INTO
BANkS iQ. ALTHOUGH THIS
CHARGING CABLE IS SHORT AND
ITS CIRCUITRY IS FUSE-PROTECTED,
THE USER IS EXPECTED TO TAkE
APPROPRIATE MEASURES TO
PREVENT SMALL CHILDREN AND/
OR PETS FROM CONTACT WITH ANY
PART OF THIS SYSTEM.
9.
Secure Banks iQ Bridge Module
under the dash to any dash frame
support using the supplied cable ties.
Use the cable tie support loops on the
side of the Bridge Module to securely
fasten it under the dash.
10.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
-END SEcTION 2-
Figure 10 Mounting location for Banks iQ