Banks Power 2001-2005 Chevy_GMC 6.6L Duramax Turbo-Diesel Pickups User Manual
Page 12
12
96452 v.11.0
8.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash.
9.
Double check everything to make
sure it is securely fastened and it
is not near any hot or moving parts
before starting engine.
10.
Set up the Banks PowerPDA
according to it’s instructions.
11.
Locate the Banks OBD II Interface
cable in your kit. This cable has
three connection points. connect the
RED OBD II connector on the Banks
interface cable to the vehicle OBD II
connector. Use a cable tie as shown in
Figure 6 to secure the Banks interface
cable to the vehicle OBD II connector.
Next, connect the 6-pin connector on
the Banks OBD II interface cable to the
6-pin connector on the Six-Gun Tuner
harness.
WARNING: The PDA may be
susceptible to damage as a
result of extended exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the PDA be removed from
its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage to
PDA’s resulting from exposure
conditions.
-END, SEcTION 2-
Figure 7