For installation of the speed-loader option – Banks Power 2001-2005 Chevy_GMC 6.6L Duramax Turbo-Diesel Pickups User Manual
Page 14
14
96452 v.11.0
6.
After confirming the locating
washer is in the #6 location, install the
switch through the
3
⁄
8
” hole on the
backside of the instrument panel. The
alignment pin should rest in the
1
⁄
8
”
hole and with the switch fully rotated
counter clockwise; the shaft’s flat side
should be facing the steering column.
Secure switch with internal tooth
washer and nut. Snug the washer; be
careful not to over torque the nut and
damage the plastic threads.
7.
Install the knob onto the shaft
facing the #1 Level on the Six-Gun
label. On the knob, snug the two (2)
set screws with the supplied 0.050”
hex key wrench.
8.
Route the Six-Gun Switch cable
down to the Six-Gun Diesel Tuner’s
three-connector cable underneath the
dashboard, and reinstall the IP to the
dashboard.
9.
Connect the Six-Gun Switch Cable’s
2-pin receptacle to the 2-pin plug on
the Six-Gun Diesel Tuner’s grey three-
connector cable.
For installation of the
Speed-Loader option:
CAUTION: When a Speed-Loader is
installed, Level 6 is re-calibrated
for maximum possible power
output—this includes removal of
the 5th gear power de-rate, and a
raised EGT limit (to 1500 °F). With
a Speedloader installed, Level 6
should only be used in unloaded,
off-road conditions for short
amounts of time, NEVER on-road
or under heavily loaded conditions
where extremely high exhaust
gas temperatures could lead to
turbocharger and engine damage.
WARNING: if excessive torque
converter slip is detected then
a Limp Home Mode override will
be set by the ECU. This LHM will
be active until torque slippage is
no longer detected or is reset by
Diagnostic Tool.
a.) Install the 4-pin connector of the
Speed-Loader harness to the 4-pin
connector on the Speed-Loader
module.
b.) Verify the Banks wire harness,
Six-Gun Diesel Tuner and Six-Gun
switch are installed as specified in
the Owners Manual. Disconnect
the Six-Gun Switch from the 2-pin
plug on the Six-Gun Diesel Tuner’s
grey three-connector cable.
c.) Connect the Six-Gun switch’s 2-pin
receptacle to the Speed-Loader’s
2-pin plug. connect the Speed-
Loader’s 2-pin receptacle to the
2-pin plug on the Six-Gun Diesel
Tuner’s grey three-connector
cable.
d.) If necessary, wire tie the Speed-
Loader module and harness under
the dash away from pedals or any
moving components.
Note: the optional Speed-Loader
provides access to an additional
power level of the Six-Gun Diesel
tuner. Installing the Speed-Loader will
allow levels 2 through 6 to experience
an increase in power above that
of the Banks Six-Gun Diesel tuner