Banks Power 2001-2005 Chevy_GMC 6.6L Duramax Turbo-Diesel Pickups User Manual
Page 18
18
96452 v.11.0
Once the Speed-Loader Module is
installed or removed from the vehicle,
the following learning sequence will
need to be performed so that the Six-
Gun Diesel Tuner can correctly identify
that the Speed-Loader is present or
absent.
1.
Start the engine
2.
Turn the Six-Gun switch to the
highest level (position 6) and stay
there for five (5) seconds.
3.
Rotate the switch to the lowest
level (position 1) and stay for five (5)
seconds.
4.
Rotate the switch again to the
highest level (position 6) and stay
there for five (5) seconds.
Note: to determine if the Banks
Six-Gun Diesel tuner is running the
Speed-Loader programming, watch
the GReeN LeD on the tuner and turn
the ignition switch to the oN position
(BUt Do Not StARt tHe eNGINe).
If the GReeN LeD flashes, the Banks
Six-Gun Diesel tuner will run with the
Speed- Loader programming. If the
GReeN LeD doesn’t flash, the Banks
Six- Gun Diesel tuner will run the
standard programming. If the GReeN
LeD does not indicate the same status
as your Six-Gun and Speed-Loader
setup, repeat the above steps.
-END, SEcTION 5-
the Six-Gun harness with the supplied
nuts and bolts. cover this joint with
the supplied heat shrink tubing and
heat until the tubing conforms to the
joint. Make sure the entire joint is
insulated.
10.
Reconnect the ground cables to
the vehicles batteries.
Note: once the Six-Gun Diesel
tuner is powered up at key-on, it
will ‘learn’ that a thermocouple
is installed and automatically
enable the eGt limiting function.
If the thermocouple is removed after
being installed and run on the vehicle,
the Six-Gun Diesel tuner will assume
that the sensor or connection has gone
bad, and cease adding power while
triggering the [2,3] diagnostic code
(see trouble Shooting Section 8). to
ensure that the Six-Gun Diesel tuner
operates properly after removing a
previously installed thermocouple,
see the ‘Clearing Learned Information’
Section 9. eGt limiting will not be
operational and excessive eGts
may develop at higher power
levels.
-END, SEcTION 4-
Section 5
SPEED-LOADER LEARNING SEqUENCE
(APPLIES TO SIx-GUN SWITCH INSTALLATIONS ONLY)