Rainbow Electronics AT89LP214 - Manual (Page 22)

22
3538A–MICRO–7/06
AT89LP213/214 [Preliminary]
13. I/O Ports
The AT89LP213/214 can be configured for between 9 and 12 I/O pins. The exact number of I/O
pins available depends on the clock and reset options as shown in
Table 13-1 . All port pins are
5V tolerant, that is they can be pulled up or driven to 5.5V even when operating at a lower V
CC
such as 3V.
13.1 Port Configuration
All port pins on the AT89LP213/214 may be configured to one of four modes: quasi-bidirectional
(standard 8051 port outputs), push-pull output, open-drain output, or input-only. Port modes may
be assigned in software on a pin-by-pin basis as shown in
Table 13-2 . The Tristate-Port User
Fuse determines the default state of the port pins. When the fuse is enabled, all port pins default
to input-only mode after reset. When the fuse is disabled, all port pins, with the exception of P1.0
and P1.1, default to quasi-bidirectional mode after reset and are weakly pulled high. Each port
pin also has a Schmitt-triggered input for improved input noise rejection. During Power-down all
the Schmitt-triggered inputs are disabled with the exception of P1.3, P3.2 and P3.3, which may
be used to wake up the device. Therefore P1.3, P3.2 and P3.3 should not be left floating during
Power-down
Table 12-4. IPH – Interrupt Priority High Register
IPH = B7H Reset Value = X000 0000B
Not Bit Addressable
– – PGH PSH PT1H PX1H PT0H PX0H
Bit 7 6 5 4 3 2 1 0
Symbol Function
PGH General-purpose Interrupt Priority High
PSH Serial Port Interrupt Priority High
PT1H Timer 1 Interrupt Priority High
PX1H External Interrupt 1 Priority High
PT0H Timer 0 Interrupt Priority High
PX0H External Interrupt 0 Priority High
Table 13-1. I/O Pin Configurations
Clock Source Reset Option Number of I/O Pins
External Crystal or Resonator
External RST Pin 9
No external reset 10
External Clock
External RST Pin 10
No external reset 11
Internal RC Oscillator
External RST Pin 11
No external reset 12