Peerless-AV ACC925 - Installation - Manual (Page 3)

3 of 9 ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800-865-2112.
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen.
Place screen face side down. If screen has knobs on the back, remove them to allow the adapter brackets to be
attached. Place flat or tilt brackets (not included) on back of screen, align to holes, and center on back of screen as
shown below. Attach the adapter brackets to the back of the screen using the appropriate combination of security
screws, multi-washers, and spacers as shown in steps 2-1 and 2-2 on page 4.
NOTE: Top and bottom holes on screen must always be used.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
NOTE: For fl at back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.
Notes:
• The number of fasteners used will vary,
depending upon the type of screen.
• Multi-washers (G) and spacer (H) may
not be used, depending upon the type of
screen.
• Use the corresponding hole in the multi-
washer that matches your screw size.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
MULTI-WASHER (E)
NOTE: "X" dimensions should be equal.
X
X
CENTER BRACKETS
VERTICALLY
ON BACK OF
SCREEN
FLAT BRACKETS
CENTER BRACKETS
VERTICALLY
ON BACK OF
SCREEN
TILT BRACKETS
X
X
2