Peerless-AV ACC925 - Installation - Manual (Page 4)

4 of 9 ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800-865-2112.
For Flat Back Screen
For Bump-out or Recessed Back Screen
Begin with the shortest length screw, hand thread through multi-washer and flat or tilt adapter bracket (not
included) into screen as shown below. Screw must make at least three full turns into the mounting hole and fit
snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length
screw from the security fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
Begin with longer length screw, hand thread through multi-washer, flat or tilt adapter bracket (not included) and
spacer in that order into screen as shown below. Screw must make at least three full turns into the mounting hole
and fit snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer
length screw from the security fastener pack. Repeat for remaining mounting holes, level brackets and tighten
screws.
2-1
2-2
If you have any questions, please call Peerless customer care at 1-800-865-2112.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
FLAT
BRACKET
SCREEN
MULTI-WASHER
SCREW
SCREEN
MULTI-WASHER
SCREW
TILT
BRACKET
FLAT
BRACKET
SCREEN
SPACER
MULTI-WASHER
SCREW
ADAPTER
BRACKET
SCREEN
SPACER
MULTI-WASHER
SCREW
TILT BRACKETS
TILT BRACKETS FLAT BRACKETS
FLAT BRACKETS