Peerless-AV ACC925 - Installation - Manual (Page 6)

6 of 9 ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12
Visit the Peerless Web Site at www.peerless-av.com For customer care call 1-800-865-2112.
NOTE: Refer to main instructions for adjustments of universal adapter bracket extension brackets.
NOTE: If your screen has a VESA hole pattern skip to page 8.
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place
screen face side down. Refer to screen manufacturer's instructions for removal of knobs, base, cover, or screw(s)
on the back of the screen to prepare for mounting screen brackets to screen. Adjust screen brackets to align with
screen mounting holes as shown below. Select the small, medium, large or extra large screws from the security
fastener pack then attach screen brackets to screen following steps 1-1 and 1-2 on page 7.
NOTE: Top and bottom mounting holes must be used for attaching screen brackets. Middle holes should also be
used where the fasteners and screens allow.
Verify that all holes are properly aligned, and then tighten screws using a phillips screw driver.
If installing security screws for PF or PT wall mount models, go to page 2.
1
Installing Security Screws for SA wall mount models
• Tighten screws so screen brackets are fi rmly attached to screen. Do not tighten with excessive force. Overtightening
can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to
become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
WARNING
NOTE: For fl at back screens proceed to step 1-1. For bump-out or recessed back screen skip to step 1-2.
CENTER SCREEN BRACKETS VERTICALLY ON BACK OF SCREEN
SCREEN
ADAPTER BRACKETS
SCREEN BRACKETS
Notes:
• The number of fasteners used will vary,
depending upon the type of screen.
• Multi-washers (G) and spacer (H) may
not be used, depending upon the type of
screen.
• Use the corresponding hole in the multi-
washer that matches your screw size.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
MULTI-WASHER (E)
NOTE: "X" dimensions should be equal.
"Y" dimensions should be equal.
Y Y
X
X