Peerless-AV ACC925 - Installation User Manual
Page 7
7 of 9
ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12
Visit the Peerless Web Site at www.peerless-av.com
For customer care call 1-800-865-2112.
SCREEN
MULTI-WASHER
SCREEN
BRACKET
SCREW
Begin with the shortest length screw, hand thread screw through multi-washer and screen brackets (not included)
into screen as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into
place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from
the fastener pack. Repeat for remaining mounting holes, level screen brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Flat Back Screen
1-1
SCREEN
MULTI-WASHER
SCREW
SPACER
Begin with longer length screw, hand thread screw through multi-washer, screen brackets (not included) and
spacer in that order into screen as shown below. Screw must make at least three full turns into the mounting hole
and fi t snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer
length screw from the fastener pack. Repeat for remaining mounting holes, level screen brackets and tighten
screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Screen
1-2
SCREEN
BRACKET