SENA Parani-SD100-200 - Manual (Page 23)

23
In this example we will refer to the two Parani-SDs as SD1 and SD2 respectively. To use this menu,
please do the following:
Step 1. Connect SD1 and then push the START button.
Step 2. Disconnect SD1, connect SD2 and then push the Next button after setting up Slave
configuration. At this time, the dip switch value should be ATcmd mode. The flow control setting can
be changed only through dip switch.
Step 3. Disconnect SD2, once again connect SD1 and then push the Finish button. The pairing
configuration should be completed. Make sure that each Parani-SD’s connect LED is on. At this
point, when both Parani-SD’s restart the connection will be established automatically.
3.11 ParaniUpdater
Parani-SD supports firmware updates. You can download new firmware images for the Parani-SD at
http://www.sena.com . With the ParaniUpdater, you can update the firmware of Parani-SD by selecting
the firmware image file and pushing Start button.
* Note: DO NOT power off Parani-SD while the firmware update is progressing, this may damage the
Parani-SD.
Figure 3-11 ParaniUpdater Window
3.12 Terminal Program
A terminal program is typically an application that will enable a PC to communicate directly with a
modem. If you are using Windows 98SE or higher version of Windows, HyperTerminal program is
included as part of the operating system. Parani-SD provides some extended AT commands for
configuration of the Parani-SD.
This manual will explain the method using HyperTerminal. If you need to install HyperTerminal, click
start>setting>control panel>add/remove programs. For more precise details on HyperTerminal
installations, please refer to Microsoft Windows Help section..