SENA Parani-SD100-200 - Manual (Page 39)

39
B.3.31. AT&V

Response  S0:m0;S1:m1; …Sn:mn
 OK
Purpose Display all the S-registers
Description All parameters are stored at S-register in flash memory. These values are sustained until a
hardware reset.
Reference ATS
B.3.32. ATSnn?

Response  value
 OK
Purpose Display a given S-register
Parameters nn= Address of S-register
Description A specific S-register will be displayed.
Reference AT&V
B.3.33. ATSnn=mm

Response  OK
Purpose Change S-register value
Parameters nn= Address of S-register
mm= New value of S-register
Description Some S-registers are optimized for the overall performance and protected and cannot be
changed. When users try to change these S-registers, response is ‘ERROR’.
For details of S-register, refer Appendix. B.
Reference AT&V
Example ATS10=0
B.4. Command Validity
Operation Status AT Command
Standby Pending Connect
AT ○ ○
ATZ ○ ○
AT&F ○ ○
AT+BINQ? ◎
ATD112233445566 ◎