SENA NEMO10-SK - Manual (Page 15)

15
2.2.1 Install The NEMO10 Onto The Test Bed
Plug the NEMO10 module onto the test bed. Refer to the Figure 2-4 for the installation.
Figure 2-4 Installation of the NEMO10 module to the test bed
2.2.2 Connecting The Power
Connect the power jack to the power jack of the test bed using DC power adapter included in the
package. If the power is properly supplied, the [Power] LED of the test bed will maintain solid red.
Figure 2-5 Connecting the power to the test bed
2.2.3 Connecting To The Network
Connect the one end of the Ethernet cable to the 10Base-T port o the test bed and the other to the
Ethernet network. If the cable is properly hooked up, the NEMO10 will have a valid connection to the
Ethernet network by indicating:
- [Link] LED of the test bed maintains solid green
- [Collision/Act] LED continuously blinks to indicate the incoming/outgoing Ethernet packets