SENA NEMO10-SK - Manual (Page 20)

20
2.4 Command Usage
The NEMO10 provides several simple commands for configuration and control of the NEMO10. Table
2-4 summarizes command set which NEMO10 supports.
Table 2-4 NEMO10 command set summary
Command Description Result
set group par1 [par2 ...] + <CR> Set configuration parameters
- group = 'ip', 'host', 'serial' or 'admin'
- par1 ... = configuration parameters. Use * to
keep a parameter's value If success,
“OK” + <CR> + <LF>
If error
“ERROR” + <CR> + <LF>
get [group] + <CR> Get configuration parameter values
- group = 'ip', 'host', 'serial', 'admin' or 'status'
- If group is specified, shows settings of the
group.
- If group is omitted, shows settings of all groups. Parameter value display
help [group] + <CR> Shows command usage screen.
- If group is omitted, shows help screen.
- If group is specified, shows 'set' command
usage of the group. Help message display
factorydefault [option] + <CR> Restore factory default values
- if option is omitted, all parameters are set with
factory default values.
- if option='-ip', all parameters except IP settings
are set with factory default values. If success,
“OK” + <CR> + <LF>
If error
“ERROR” + <CR> + <LF>
save + <CR> Save changes If success,
“OK” + <CR> + <LF>
If error
“ERROR” + <CR> + <LF>
exit + <CR> Exit without rebooting the device (changes are
not applied) If success,
“OK” + <CR> + <LF>
If error
“ERROR” + <CR> + <LF>
reboot + <CR> Exit and reboot the device None
2.4.1 ‘set’ Command
With ‘set’ command, users can configure parameter values of the NEMO10 for each environment.
Basic ‘set’ command usage is as follows:
set group par1 [par2 ...] + <CR>
where,
group = 'ip','host','serial' or 'admin'
par1 par2 ... = configuration parameters. Use * to keep a parameter's value