SENA NEMO10-SK - Manual (Page 25)

25
2.4.6 ‘exit’ Command
With ‘exit’ command, current serial or remote console session will be closed. However, changed
parameters are not applied until the NEMO10 is manually rebooted. Command usage of ‘exit’
command is as follows:
exit + <CR>
2.4.7 ‘reboot’ Command
With ‘reboot’ command, the NEMO10 will be rebooted immediately. Changed parameter values will be
applied when the NEMO10 is up again. Command usage of ‘reboot’ is as follows:
reboot + <CR>