Billet Specialties V-Trac Pulley System - Small Block Chevy - Manual (Page 11)

11
Figure 8 - Install Belt
Route belts as shown in appropriate diagram, adjust alternator belt tension
first. Tighten alternator mounting hardware firmly. Adjust compressor belt
tension, tighten rear compressor shoulder bolt firmly then front compressor
cap screw firmly. Finish by tightening the top compressor cap screw.
Re-check all fasteners for tightness and proper belt tension. Connect all
electrical and start motor and allow to warm up. Turn motor off and re-check
fasteners and belts. Re-check after 100 miles.
Alternator Belt Length:
• With Power Steering - 43.5” / Goodyear #15440
• Without Power Steering - 41.5” / Goodyear - #15420
Compressor Belt Length: 42.5” / Goodyear - #15430
With Power Steering Without Power Steering