Billet Specialties V-Trac Pulley System - Small Block Chevy - Manual (Page 9)

9
Figure 6 - Install Crank Pulley, Water Pump Pulley
& Compressor Clutch Cover
Install the crank pulley by applying anti-seize to the threads of the three
3/8-24 x 1” socket head cap screws, install the three 3/8” Belleville washers
onto each cap screw and thread through crank pulley into damper.
Install the water pump pulley by applying anti-seize to the threads of the
four 5/16-24 x 1/2” socket head cap screws and threading them through the
water pump pulley into flange.
Install AC Compressor Clutch Cover
Apply Loctite Blue 242 to the following:
(3) 1/4-20 x 3/4” socket head cap screws
Place cover on clutch and thread the socket head cap screws through the
cover and into the clutch, torque to 40-45 inch/lbs.
Caution: Over tightening these festeners will cause damage to the compres-
sor clutch. Do Not Over Tighten.
Tighten all fasteners firmly.