Billet Specialties V-Trac Pulley System - Small Block Chevy - Manual (Page 5)

5
Figure 2 - Install Alternator & A/C Brackets
Install the large O-rings into both sides of the passenger side compressor
bracket by seating them into the recessed groves, install the small by-pass
O-rings in the same manner. Place bracket over studs and seat up against
engine block.
Install the large O-rings into both sides of the driver side alternator bracket by
seating them into the recessed groves. Place bracket over studs and seat up
against engine block.
For kits with power steering – apply anti-seize to the threads of the two
3/8-16 x 2” socket head cap screws and thread through the power steering
bracket, alternator bracket and into engine block and finger tighten.
For kits without power steering – apply anti-seize to the threads of the two
3/8-16 x 1-1/4” socket head cap screws and thread through the alternator
bracket and into engine block and finger tighten.