OSRAM POWERTRONIC PT-FIT I ECG for HID lamps, with cable clamp - Manual (Page 29)

THE PRODUCT IN OPERATION
29
B version for installation in luminaires: PTi I version for independent mounting with cable clamps:
PTi SNAP version for independent mounting with inte-
grated connectors
PTo for installation in luminaires:
Figure 29: PT-FIT 70/220-240 B Figure 31: PTi 70/220-240 I
Figure 32: PTi 70/220-240 SNAP
Figure 30: PTo 100/220-240 3DIM
• Mounting the device using grommets on the bottom
• Plug terminals for fast connection and release of wires
without the need for tools
• The luminaire casing must provide protection in order to
satisfy the EN 60598-1 and EN 61347-2-12 safety stan-
dards
• Large terminal compartment gives good access to terminals
• A generously proportioned terminal compartment allows for
a fl oating terminal for mains looping
• The LUM PE connection allows safe and lasting direct
earthing of the luminaire via the ECG's protective earth
• Cable clamp suitable for a variety of cable types and
diameters between 7 and 11 mm
• PTi variants 20, 35, 50 and 70 offer mains looping
• Separate cable clamps for separate access to primary and
secondary side
• Only a single screw per cable clamp cap for fast and yet
secure cable fi xation
• With integrated universal ST18 plug connection on the
lamp side and GST18 plug connection on the mains side
for fast, error-free installation
• With cable clamp integrated into casing
• Mounting the device using grommets on the bottom
• Plug terminals for fast connection and release of wires
without the need for tools
• Robust plastic casing
• For protection against moisture and damp, the inside
of the casing (board) is potted