SCANTECH ID (Champtek company) LG700BT - Manual (Page 15)

7
3.3 LG700BT Setup Bluetooth Communication
3.3.1 Pairing
Pairing refers to when a LG700BT scanner has been linked
or paired to a specific cradle by scanning that cradle’s
Bluetooth MAC address code. This Bluetooth MAC address
code is unique for each cradle. This address code is
located on the bottom side of the cradle. The pairing of
a LG700BT scanner to a cradle is one to one. Only one
LG700BT scanner can be paired to a cradle at any point in
time.
3.3.2 Setup SPP Master Mode Communication
To setup the communication between the LG700BT scanner
and the cradle, follow the steps:
1. The LG700BT scanner must scan “SPP Master Mode”
barcode to set the LG700BT scanner in Master mode.
2. Scan the Bluetooth MAC address code located on the
bottom of the cradle.
3. When the Bluetooth MAC was successfully scanned,
scanner will initiate with 3 short beep sounds. Blue
LED will blink followed by a long beep sound.
4. Wait approximately five seconds, for completing the
connection process. Blue LED will slow flash on
scanner for connecting the cradle.
5. If successful, the blue LED on the cradle will be on.
6. If the connections failed, the blue LED on scanner
will be off, and the cradle indicators blinking blue
LED.