SCANTECH ID (Champtek company) LG700BT - Manual (Page 51)

43
4.16 Industrial 2 of 5 Parameters
4.16.1 Reading Type
IATA25 Enable
<IATA25 Disable>
4.16.2 Check Digit Transmission
<Do Not Calculate Check Digit>
Calculate Check Digit and Transmit
Calculate Check Digit and Not
Transmit
4.16.3 Setup Code Length
To set the fixed length: (2 sets available)
1. Scan the “Begin” programming code of the desired
set
2. Go to the Decimal Value Table in Appendix A. Scan
programming codes that represent the length to be
read.
3. Scan the “Complete” programming code of the desired
set.
Repeat the steps 1 – 3 to set additional length.