SCANTECH ID (Champtek company) NOVA N-4070 - Manual (Page 17)

Installation 11
This scanner can be installed on a counter surface. Instructions for
installation on a counter surface are given in Section 2.3.
Due to many POS systems on the market, a variety of communication
cables are available. Make sure that you have the right cable to connect the
scanner to your POS or computer.
NOTE
The scanner and the host system must be switched off before
starting the installation of the scanner. By following this
precaution you prevent any electrical damage.
You are advised to install the scanner in an air circulated place
out of direct sunlight.
2.1 CONNECTING THE SCANNER
To properly connect the scanner, do the following:
1. Plug the interface cable (in port 1) and ensure the scanner is properly
connected to the host.
2. Connect the power adapter. The scanner will automatically activate and
detect the setup interface.
3. Press the Volume Button ( see page 5) repeatedly to adjust the
frequency and volume level.
Use the illustration below to see where to connect your cable(s) to the
scanner.