Installing the trip paddle, Installation completed, Front frame assembly, showing the old trip paddles – GE Industrial Solutions ProTrip Conversion Kits AK-1-50 User Manual
Page 8: Installing, The new trip paddle
Advertising
SECTION 5. FRONT FRAME
BREAKER CONVERSION
Place the front frame on a suitable work surface as
shown in Figure 8.
Installing the Trip Paddle
1. Remove and discard the three trip paddles on the trip
actuator bar, as shown in Figure 8.
2. Assemble the trip paddle and the threaded back
plate by inserting two of the 10-32 x
3
/
4
" screws and
lock washers provided along the top edge.
3. Slip the trip paddle over the trip actuator bar
approximately one inch from the side frame, as
shown in Figure 9. Insert the remaining 10-32 x
3
/
4
"
screw and tighten the other screws to secure the trip
paddle in place.
Figure 8. Front frame assembly, showing the old trip
paddles.
Figure 9. Installing the new trip paddle.
8
Advertising