GE Industrial Solutions ProTrip Conversion Kits AK-1-50 - Manual (Page 9)

Installing the Flux Shifter Assembly
Figure 10 shows the flux shifter mounting bracket, with
the trip unit support bracket and insulating shield
attached.
1. Remove and discard the grounding strap hardware
on the left side of the front frame. Attach the flux
shifter mounting bracket to the left inside of the front
frame with the two
3 / 8 -16 x 1" bolts, nuts, and lock
washers provided, as shown in Figure 11 (showing
the plate in position after reassembly of the front and
back frames).
2. Secure the flux shifter assembly, shown in Figure 10,
to the bracket with the two 1 / 4 -20 x 1 / 2 " bolts
provided, as shown in Figure 12.
Figure 10. Flux shifter assembly and mounting bracket.
Figure 11. Flux shifter bracket installed on the front frame
(view from underneath with breaker reassembled).
Figure 12. Flux shifter assembly attached to the
mounting bracket.
9