GE Industrial Solutions WattStation Pedestal EVSE Charger Installation - Manual (Page 8)

WattStation Pedestal Installation Manual
88 G GEE EEnneerrggyy © ©22001122 G GEE C Coom mppaannyy AAllll RRiigghhttss RReesseerrvveedd
6 Installation Requirements
-
Ensure that a dedicated circuit, capable of supplying 30A at 208-240 VAC, is available
- A recommended 40A upstream circuit breaker, located either in a panel board or load center,
should be used.
- GE WattStation EVSE unit has built in GFCI protection; do not provide any additional GFCI
protection upstream of the EVSE.
7 Torque Specification Table
SSC CRREEW W SSIIZZEE TTO ORRQ QU UEE TTO ORRQ QU UEE TTO OLL..
PDB – Power Distribution Block for
Field Wiring
40 in-lb +/- 2 in-lb
Ground lug 45 in-lb +/- 2 in-lb
Roller –M5x12, Cup Point set screw 18 in-lb +/- 2 in-lb
Brush – T-15 Driver size
(Tamperproof Head)
23 in-lb +/- 2 in-lb
Brush bracket – M5 Hex Head 23 in-lb +/- 2 in-lb
Bellows bracket top – M5 Philips Head 23 in-lb +/- 2 in-lb
Bellows bracket bottom – M5 Philips Head 23 in-lb +/- 2 in-lb
Bellows plate – M3 Nut 18 in-lb +/- 2 in-lb
Wire trays top – M5 Hex Head 23 in-lb +/- 2 in-lb
Wire trays bottom– M5 Hex Head 23 in-lb +/- 2 in-lb
Anchoring bolts – ½” x 6” Hex Head 20 in-lb +/- 2 in-lb
TTaabbllee 11
W WaattttSSttaattiioonn sshhoouulldd bbee iinnssttaalllleedd oonnllyy bbyy aa lliicceennsseedd ccoonnttrraaccttoorr,,
aanndd//oorr aa lliicceennsseedd eelleeccttrriicciiaann iinn aaccccoorrddaannccee w
wiitthh aallll aapppplliiccaabbllee
ssttaattee,, llooccaall aanndd nnaattiioonnaall eelleeccttrriiccaall ccooddeess aanndd ssttaannddaarrddss..
WARNING: