GE Industrial Solutions Programmer Disconnect - Manual (Page 12)

11 Programmer Disconnect — Accessory Manual for Retrofil CB DEH-41532 02/12
Wiring and Task Completed
1. The breaker side programmer disconnect assemblies comes pre-installed and wired from the factory. Hence no
action is needed on the breaker.
2. Verify that the compartment side programmer disconnect assembly wiring scheme matches that of the breaker
side wiring scheme.
3. A typical wiring diagram used for the programmer disconnect on the breaker side is shown in Figure 13 .
Figure 13. Typical Programmer disconnect Wiring Scheme for Retrofill EntelliGuard ACB in AKD8 LVS
• Top row: Terminal numbering on programmer disconnect
• Bottom row: Terminal number for A & B Secondary disconnects of EntelliGuard breaker
• Arrows point to the terminal blocks.