GE Industrial Solutions Programmer Disconnect - Manual (Page 4)

3 Programmer Disconnect — Accessory Manual for Retrofil CB DEH-41532 02/12
Figure 2. EntelliGuard G 39-Point Secondary B-Block
• Turn off all power to switchgear. Tagout
and lockout main source, up-stream or
main breaker.
• Failure to comply with these instructions
will result in death or serious injury from
severe burns caused by arc flashing that
has exceedingly high temperatures.
• Always wear personal protection equipment
according to OSHA standards and appropriate
to the severity of potential burns.
• Ensure only qualified personnel install, operate, service, and maintain all electrical equipment.
• It should be always verified that the LVS stack is de-energized before any of the control wiring is established from
the LVS to the EntelliGuard Secondary disconnect blocks
CAUTION
• Wrong connections will cause the breaker
to malfunction.