Warning, Notice – GE Industrial Solutions Tranquell Series Low and Medium User Manual
Page 18
2020005003 (12/09) Page 18 of 18
SERVICING / TROUBLESHOOTING:
The GE Tranquell Series SPD contains no user serviceable parts and requires no calibration. The
rugged design of the SPD should provide many years of service.
Should a condition occur that results in premature failure of the GE Tranquell SPD, the integral
fusing or required circuit breaker will safely interrupt current flow through the SPD without
disrupting power to the protected equipment. This will remove the SPD from the power
system and the load equipment will remain unprotected from subsequent surge activity until
the SPD is replaced.
If a change in operational status/alarm indication occurs, a qualified (licensed) electrician should
inspect the electrical system to verify electrical system integrity. If the SPD remains in alarm
after system inspection/corrections have been made, the SPD should be replaced. For further
assistance, contact your local sales representative or call GE Power Quality at 1-800-637-1738.
NOTICE
These instructions do not purport to cover all details or variations in equipment nor to provide for
every possible contingency to be met in connection with installation, operation, or maintenance.
Should further information be desired or should particular problems arise which are not covered
sufficiently for the purchaser's purposes, the matter should be referred to the GE Company.
TRANQUELL
IS A REGISTERED TRADEMARK OF GENERAL ELECTRIC COMPANY
WARNING
IN THE EVENT OF AN SPD ALARM CONDITION, DO NOT ATTEMPT
TO DIS-ASSEMBLE THE SPD TO REPLACE FUSING OR OTHER
COMPONENTS. THE SPD CONTAINS FUSING COMPONENTS THAT
WILL ONLY OPEN WHEN THE SPD HAS FAILED IN A NON-
SERVICEABLE CONDITION. THE ENTIRE SPD MUST BE REPLACED.
CONTACT GE POWER QUALITY AT 1-800-637-1738
GE Digital Energy – Power Quality
830 W 40th Street, Chicago, IL 60609 USA
800 637 1738
Information subject to change without notice.
Please verify all details with GE.
© 2009 General Electric Company All Rights Reserved