GE Industrial Solutions 6KCV301DNET - Manual (Page 10)

GEI-100435A
——————
Interface card DeviceNet
——————
10
2.3 POWER SUPPLY
The power supply is provided by the XT connector which is also used to
transfer data between the SBI card and the drive regulation card.
Current draw: 350 mA
2.4 TERMINALS
Ground terminals (6-7) DeviceNet cable shield is connected to the ground
(PE) through these terminals.
Terminal BUS See the figure below. It allows to connect the SBI
card to the DeviceNet network. The pins are the
following:
Pin Signal Description
1 CAN_GND Ground / 0V /V-
2 CAN_L Can_L bus line (dominant low)
3 CAN_SHLD CAN shield
4 CAN_H CAN_H bus line (dominant high)
5 CAN_V+
CAN external positive supply
(dedicated for supply of
transceiver and optocouplers)
dn22
2.5 LEDS
PWR +5V power supply.
RST Reset active.
H1 +5V power supply on the RS 485 driver side. It is
supplied by the Bus.
RUN It is on when the microcontroller is operating.
OP It is on when the Master/Slave connection is es-
tablished.
AL0 It blinks when the “Duplicate MAC ID” test has
not been passed.
AL1, AL2 Not used and are always off.