GE Industrial Solutions 6KCV301DNET - Manual (Page 8)

GEI-100435A
——————
Interface card DeviceNet
——————
8
2.2 INSTALLATION
The SBI card is supplied with standoffs, screws, washers and a SBI-Drive link
cable provided with connectors.
1. Switch the drive off.
2. If the card is mounted inside the drive (see example below), fasten the SBI
card to the drive regulation card by means of screws (B) and standoffs
(A). The SBI-Drive link cable (C) must be connected between XT1 (on
Regulation card) and XT connector (on SBI card).
If the card is mounted outside the drive, the SBI card has to be fastened to
a DIN rail by using the external mounting kit; it is recommended to keep
the SBI card as close as possible to the drive. Do not put the SBI-Drive link
cable near power cables.
3. The SBI-Drive link cable is connected to the XT connector on the SBI-card.